Contact Closure Input (Cci) Mode Setup - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Contact Closure Input (CCI) Mode Setup

(wired directly to the GRAFIK Eye
The integral contact closure input (CCI) on the back of the GRAFIK Eye
be configured to match the installation requirements. The choices are listed and
explained below. (See page 7 for wiring details.)
To change the operation of the contact closure input:
1. Enter programming mode (see page 15).
Main menu
2. Use the Master buttons to highlight "CCI Mode" and press the
Save Mode
OK button to accept.
CCI Mode
3. Use the Master buttons to highlight the mode you wish the
CCI to control. Press the OK button to accept.
4. The info screen will confirm that your setting has been saved.
CCI Mode
5. Exit programming mode (see page 15).
CCI Mode Settings
Occupancy
Occupancy: Allows a wired occupancy sensor to be included
in the list of available sensors when setting up occupancy
actions.
Emergency: This setting allows the GRAFIK Eye QS to work
with a LUT-ELI-3PH emergency lighting interface. When an
emergency situation is detected, all lights will go to full on,
Saved
Saved
and no operations will be allowed until the emergency signal is
cleared.
Afterhours: Allows the CCI to start and end the afterhours
mode.
Timeclock: Allows the CCI to enable and disable the timeclock.
Lockout: Prevents the user from making any changes to
the control unit. The current scene will stay on until the CCI
enables normal operation.
Never Save: Prevents any changes from being saved while the
CCI is being used.
Disable CCI: The CCI will have no effect on the system and will
not appear on the list of available occupancy sensors within
the sensor setup menu.
®
QS)
1 2 3
®
4 5 6
QS can
®
GRAFIK Eye QS Installation and Operation Guide 21
®
Master
buttons
OK
OK
button
Timeclock
(back) button