Contact Closure Input (Cci) Setup; Cci Mode Settings - Lutron Electronics GRAFIK Eye QSGRN-6PCE Installation And Operation Manual

Contact Closure Input (CCI) Setup

(wired directly to the GRAFIK Eye
The integral contact closure input (CCI) on the back of the GRAFIK Eye
can be configured as:
Occupancy (default): Allows a wired occupancy sensor to be included in the list of
available sensors when setting up occupancy actions.
Emergency: This setting allows the GRAFIK Eye
LUT-ELI-3PH emergency lighting interface. When an emergency situation is detected,
all lights will go to full on, and will not change until the emergency signal is cleared.
Afterhours: Allows the CCI to start and end Afterhours.
Timeclock: Allows the CCI to enable and disable the timeclock.
Lockout: Prevents the user from making any changes to the control unit. The current scene will stay on until the CCI
enables normal operation.
Never Save: Prevents any changes from being saved while the CCI is being used.
Disable CCI: The CCI will have no effect on the system and will not appear on the list of available occupancy sensors
within the sensor setup menu.
Changing the operation of the contact closure input:
1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight "CCI Setup" and press the OK button to accept.
Save Mode
3. Use the Master buttons to highlight "CCI Mode" and press the OK button to accept.
CCI Setup
4. Use the Master buttons to highlight the mode you wish the CCI to control. Press the OK button to
accept.
5. The info screen will confirm that your setting has been saved.
CCI menu
6. Exit programming mode.
CCI Mode
CCI Type
CCI Mode
Occupancy
Saved
®
QS control unit)
®
QS control unit to work with a
®
Saved
QS control unit
®
(continued on the next page)
GRAFIK Eye QS Control Unit Installation and Operation Guide 24
®
Master
buttons
OK
OK
button
Timeclock
(back) button