Zone Setup; Assigning Load Types; Assigning Non-Dim Load Types - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Zone Setup

Assigning Load Types

1. Enter programming mode.
Main menu
2. Use the Master buttons to highlight
CCI Setup
"Zone setup" and press the
Zone setup
"OK" button to accept.
3. Use the Master buttons to highlight
"Load type." Press the "OK" button
Zone Setup to accept. See "Setting Load Types"
table on the next page.
Load Type
4. Use the zone raise/lower buttons
Non-Dim Load Type
to choose the load type for that
zone. See the list on the next page
for supported load types. Press the
"OK" button to accept.
Load Type
5. The info screen will confirm that
Set zones
your load type has been saved.
6. Exit programming mode.
Saved
®

Assigning Non-Dim Load Types

Zones assigned to non-dim loads have five available configurations:
• LOFO: Last On, First Off
Main menu
• FOFO: First On, First Off
CCI Setup
• FOLO: First On, Last Off
Zone setup
• LOLO: Last On, Last Off
• 60/40: On at 60%, off at 40%
Scenes made up of both dim and non-dim
Zone Setup
load types will toggle the non-dim loads before
the dim loads in a "First" on/off configuration,
Load Type
and after the dim loads in a "Last" on/off
Non-Dim Load Type
configuration.
1. Enter programming mode.
2. Use the Master buttons to highlight "Zone
Load Type
setup" and press the "OK" button to accept.
Set zones
3. Use the Master buttons to highlight "Non-Dim
Load type." Press the "OK" button to accept.
See "Setting Load Types" table on the
next page.
4. Use the zone raise/lower buttons to choose
the non-dim load type for that zone. (Zones
not programmed as non-dim will be displayed
Saved
as Unaffected.) Press the "OK" button to
accept.
5. The info screen will confirm that your load type
has been saved.
6. Exit programming mode.
GRAFIK Eye QS Control Unit Installation and Operation Guide 16
®
OK
1 2 3 4 5
Master
buttons
"OK" button
6
Use the
zone
raise/lower
buttons to
choose the
load type for
that zone.