Hitachi H8/3035 Series Hardware Manual page 54

Table 2-11 Addressing Modes
No. Addressing Mode
1 Register direct
2 Register indirect
3 Register indirect with displacement
4 Register indirect with post-increment
Register indirect with pre-decrement
5 Absolute address
6 Immediate
7 Program-counter relative
8 Memory indirect
1 Register Direct—Rn: The register field of the instruction code specifies an 8-, 16-, or 32-bit
register containing the operand. R0H to R7H and R0L to R7L can be specified as 8-bit registers.
R0 to R7 and E0 to E7 can be specified as 16-bit registers. ER0 to ER7 can be specified as 32-
bit registers.
2 Register Indirect—@ERn: The register field of the instruction code specifies an address
register (ERn), the lower 24 bits of which contain the address of the operand.
3 Register Indirect with Displacement—@(d:16, ERn) or @(d:24, ERn): A 16-bit or 24-bit
displacement contained in the instruction code is added to the contents of an address register
(ERn) specified by the register field of the instruction, and the lower 24 bits of the sum specify
the address of a memory operand. A 16-bit displacement is sign-extended when added.
4 Register Indirect with Post-Increment or Pre-Decrement—@ERn+ or @–ERn:
• Register indirect with post-increment—@ERn+
The register field of the instruction code specifies an address register (ERn) the lower 24 bits
of which contain the address of a memory operand. After the operand is accessed, 1, 2, or 4
is added to the address register contents (32 bits) and the sum is stored in the address register.
The value added is 1 for byte access, 2 for word access, or 4 for longword access. For word
or longword access, the register value should be even.
• Register indirect with pre-decrement—@–ERn
The value 1, 2, or 4 is subtracted from an address register (ERn) specified by the register
field in the instruction code, and the lower 24 bits of the result become the address of a
memory operand. The result is also stored in the address register. The value subtracted is 1
for byte access, 2 for word access, or 4 for longword access. For word or longword access,
the resulting register value should be even.
40
Symbol
Rn
@ERn
@(d:16, ERn)/@d:24, ERn)
@ERn+
@–ERn
@aa:8/@aa:16/@aa:24
#xx:8/#xx:16/#xx:32
@(d:8, PC)/@(d:16, PC)
@@aa:8