Installing Cutterbar Inboard Curtain - MacDon R113 Operator's Manual

3. Remove four nuts (A) from weld studs on center shield,
remove two curtain brackets (B), and remove curtain.

Installing Cutterbar Inboard Curtain

1. Open cutterbar doors to gain access to inboard curtain
nuts. Refer to
Opening Cutterbar Doors, page
2. Install curtain onto weld studs on center shield, install
two curtain brackets (B), and secure with four nuts (A).
169820
MAINTENANCE AND SERVICING
159.
164
Figure 4.89: Inboard Curtain, Nuts, and Brackets
Figure 4.90: Cutterbar Doors
Figure 4.91: Inboard Curtain and Brackets
Revision A