Attaching R1 Series Self-Propelled Header To M155E4 Windrower: Self-Aligning Hydraulic; Center-Link - MacDon R113 Unloading And Assembly Instructions

3.2 Attaching R1 Series Self-Propelled Header to M155E4
Windrower: Self-Aligning Hydraulic Center-Link
1. Remove hairpin (B) from clevis pin (A) and remove
clevis pin from the header supports (C) on both sides of
the header.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to the windrower, ensure the float engagement
pin is installed in storage position (B) and NOT in
engaged position (A).
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Before starting engine, remove protective cover from exhaust stack.
2. Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
214075
ATTACHING HEADER TO WINDROWER
19
Figure 3.17: Header Support
Figure 3.18: Header Float Linkage
Figure 3.19: Ground Speed Lever
Revision A