Assembling Hazard Lights - MacDon R113 Unloading And Assembly Instructions

3.5 Assembling Hazard Lights

Detach the hazard light bracket from the shipping bracket, and install onto the frame.
1. Detach hazard light bracket (A) from shipping bracket (B) by
removing four bolts (C), washers (D), and nuts (E). Retain
the hardware for installation.
2. Detach shipping bracket (A) from the header by removing
four bolts (B), washers (C), and nuts (D). Discard the
hardware.
3. Install hazard light bracket (A) with hardware retained from
Step 1, page 19. Install four bolts (B) and washers (C) from
above, and secure with nuts (D) from below the frame.
4. Repeat all the steps on the opposite side of the machine.
262300
ASSEMBLING HEADER
C
Figure 3.14: Hazard Light Shipping Bracket –
Right Side
B
C
Figure 3.15: Hazard Light Shipping Bracket –
Right Side
A
Figure 3.16: Hazard Light Bracket – Right Side
19
E
D
B
A
A
A
D
B
C
D
Revision A