Removing Driveline On An R113 - Large Driven Drums - MacDon R1 Series Installation Instructions Manual

Before removing the existing cutterbar, you must remove the
drivelines from the machine. The procedure varies slightly
depending on the type of driven drums installed on the
machine. Some machines have large driven drums (A) and some
have small driven drums (B). Refer to the procedure appropriate
for your machine:
• R113: 3.3.1 Removing Driveline on an R113 – Large
Driven Drums, page 11
• R116: 3.3.2 Removing Driveline on an R116 – Small
Driven Drums, page 14
NOTE:
Drums vary slightly depending on the year of manufacture, so
there may be some small differences between the drums in the
illustration and the drums installed on your machine.
3.3.1 Removing Driveline on an R113 – Large Driven Drums
To remove the vertical driveline from a machine with large driven drums, follow these steps:
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
If you are working on an R116 with small driven drums, refer to
page 14.
NOTE:
Retain all parts for reassembly unless otherwise stated.
1. On the left side of the cutterbar, remove four M10 hex
flange head bolts (A) and remove vertical driveshield (B).
214497
INSTALLATION INSTRUCTIONS
A
Figure 3.9: Large and Small Driven Drums
3.3.2 Removing Driveline on an R116 – Small Driven Drums,
Figure 3.10: Driven Drum
11
B
A
B
Revision D