Removing The Driven Deflector - MacDon R85 Operator's Manual

4. Check that deflectors (A) are not damaged or bent by
rocks and for loose fasteners.
5. Replace deflectors (A) if they are severely damaged or
worn. Do NOT repair. Refer to:
•
Removing the Driven Deflector, page 137
•
Installing the Driven Deflector, page 138
•
Removing the Driveline Deflector, page 138
•
Installing the Driveline Deflector, page 139
6. Tighten loose fasteners.
WARNING
Ensure cutterbar is completely clear of foreign
objects. These objects can be ejected with
considerable force when the machine is started and
may result in serious injury or machine damage.
7. Close the cutterbar doors.
Doors, page 28.
Removing the Driven Deflector
Follow these steps to replace the driven rotary deflector:
1. Lower the header fully.
2. Shut down the engine and remove the key.
3. Open cutterbar doors. Refer to
page 28.
4. Remove four bolts (A).
5. Remove cover (B) and deflector (C).
169455
MAINTENANCE AND SERVICING
Refer to
5.5 Cutterbar
5.5 Cutterbar Doors,
137
Figure 7.46: Rotary Deflector
Figure 7.47: Driven Deflector
Revision F