Forcing Io-Link Ports - WAGO 765-4102/0100-0000 User Manual

Commissioning
You have three options for each pin that supports the forcing function:
Option
Forcing – substitute value bit is set
(1)
Forcing – substitute value bit is
deleted (0)
No forcing for this pin
To enter these, there are two checkboxes in the table for each pin of a port: force for
switching the forcing functionality on/off, and set/clr for setting or deleting the setpoint (1
bit); the latter checkbox is only relevant if the force box is checked. The following applies
to this process:
All inputs for input simulation are entered in the right half of the table under "Input process
data"; all the inputs for output forcing are then entered in the left half of the table under
"Output process data."
You can find a description of and more information on the forcing function, as well as ex-
planations of terms, in section
Each of the eight ports (X01 ... X08) has its own table row.

10.2.2.4.10 Forcing IO-Link ports

To access the forcing functionality for the IO-Link module via the Webserver, you must be
logged in there with operator or administrator rights. To perform forcing, proceed as fol-
lows:
• Select the IOL Forcing option from the main menu of the Webserver on the left and
check the Forcing enable box at the top
92 Product manual | Version: 2.1.0
8PORT IOL-B FLD PN DC 24V 2.0A
Figure 29: DIO Forcing Menu Item, "DIO Forcing" Screen
Table 56: Input Options for Forcing for Each Pin of a Port
"Force" Checkbox
Checked
Checked
Not checked
8 Forcing
[} 25].
765-4102/0100-0000
"Set/Clr" Checkbox
Checked
Not checked
No meaning