Table 36 "Do" (Digital Output) Parameters - WAGO 765-4102/0100-0000 User Manual

765-4102/0100-0000
Parameter Group
Digital configuration
Digital port parame-
ters
Product manual | Version: 2.1.0
8PORT IOL-B FLD PN DC 24V 2.0A
Parameters Default
DI logic I/Q pin 0
DI filter time I/Q pin 0
DO static on I/Q pin 0
DO static on C/Q pin 0
Enable port diagnos- 1
tics
Configuration source 1
I/Q behavior 0
Table 36: "DO" (Digital Output) Parameters
Value Range Description
0: DI not inverted Operating mode of
(NO normally open) the digital input: The
signal on pin 2 is not
inverted
1: DI inverted (NC Operating mode of
normally closed) the digital input: The
signal on pin 2 is in-
verted
0: no filter No filter active for de-
tecting a signal
change of the pin 2
input signal.
30: 3 ms filter time Filter time setting for
detecting a signal
150: 15 ms filter time
change of the input
200: 20 ms filter time
signal; the filter time
is the amount of time
the signal must be
present in order for a
signal change to be
detected.
0: disable Pin 2 supplies no
output voltage
1: enable Pin 2 is a digital out-
put and supplies
+24 VDC
0: disable Pin 4 supplies no
output voltage
1: enable Pin 4 is a digital out-
put and supplies
+24 VDC
0: disable The PROFINET port
diagnostics are dis-
abled, i.e. no diag-
nostic alarms are
triggered
1: enable PROFINET port di-
agnostics are en-
abled.
0: PDCT (Port and Configuration is per-
Device Configuration formed via a "port
Tool) and device configu-
ration tool"
1: PNIO Configuration is per-
formed via the
PROFINET IO-Con-
troller
0: not supported Pin 2 is not used
1: digital input (only Pin 2 is a digital input
class A)
2: digital output (only Pin 2 is a digital out-
class A) put
Planning
49