WAGO 765-4102/0100-0000 User Manual page 42

Planning
Parameter Group
DO substitute config-
uration
Force mode setting
42 Product manual | Version: 2.1.0
8PORT IOL-B FLD PN DC 24V 2.0A
Parameters Default
DO substitute config- 0
uration
DO substitute value 0
Force mode setting 0
765-4102/0100-0000
Table 32: "IO-Link Master" Parameters
Value Range Description
0: set low Set all digital outputs
to low level in the
event of error
1: set to defined Set digital outputs to
value a pre-defined substi-
tute value in the
event of error; if this
setting is used, the
value of the "DO sub-
stitute Value" param-
eter sets the substi-
tute value
2: hold last Hold digital outputs
at their last value in
the event of error
0 ... 65535 Substitute value as a
bitmask for the digital
outputs if the "Set to
defined value" set-
ting is used; the input
depends on the "PD
layout" parameter.
For the assignment
of bits 0 ... 15 to
ports and pins, see
the description of the
"PD layout" parame-
ter.
Use a binary-to-deci-
mal converter to cal-
culate this value.
0: enable force mode The "Forcing" operat-
ing mode is allowed
to be used (default)
1: disable force The "Forcing" operat-
mode ing mode is not al-
lowed to be used