INIM Electronics Prime Programming Manual page 91

Programming manual
This section will allow you to associate the shortcuts that are not default shortcuts, specifically
"Activate output" shortcuts. to buttonsF3 and F4 then select the respective outputs on the
expansion.
Click-on the Keys button to access the "Programming" section on the right, then select the
key that corresponds to the wireless keyfob by clicking-on the corresponding button
The "Shortcuts" section will allow you to associate the shortcuts with the buttons.
Device Button
F1
F2
O
F3
F4
11. Enroll the wireless keyfob via the simulated reader of the transceiver ([N], identified on
the keypad by the letter "W").
PROGRAMMING Keys, Enroll, "READER 00x W", "Key 00x"
At this point you have 3 minutes to enroll the wireless keyfob by pressing simultaneously
buttons F3 and F4.
The positive outcome of the operation will be signalled by 3 blinks on the green LED of the
wireless keyfob and a long audible signal on the buzzer.
12. Close the programming session after saving the modified data.
Press the Esc several times until the following message appears on the display:
EXIT? OK = YES
On pressing OK you will automatically exit the programming session, save the programmed
data and reboot of the control panel.
Using the Write button carry out a write operation.
At the end of this operation the control panel will reboot and it will possible to close the
software solution in progress.
Programming example
Table 22-5: Shortcuts for wireless keyfobs
Shortcuts
Arm/Disarm
Arm/Disarm
Activate output
Activate output
Parameter
Scenario 1 "Away"
Scenario 2 "Disarm"
Gate
Garden lights
Via software
.
Default
Yes
Yes
No
No
Via keypad
CLOSING THE
PROGRAMMING
SESSION
Via keypad
Via software
91