Table of Contents
Advertisement
Programming manual
Programming peripherals
Keypads
Setting up keypads in the system layout
Once the solution of the installation to be designed has been opened, access the "System
layout" section on the right. Here you can select the keypad to be configured and add it to the
configuration by double-clicking on the mouse.
In the section on the left, you can increase the number of keypads in the layout by clicking-on
the Keypads button.
To remove a keypad from the structure, access the programming section by clicking on the
corresponding key in the menu on the left then, from the list displayed, click on the Delete
button that corresponds to the line of the keypad to be deleted.
Type in Code (Installer), PROGRAMMING Keypads, Enable/Disable
This section allows you to add/remove keypads from the configuration, by means of keys
and
.
The Prime system provides wizards for the enrolling of wireless keypads.
Click on the Keypads button on the menu on the left, the "Programming" section on the right
will show the list of configured keypads.
Selecting "Keypad type" parameter for one of the keypads allows you to set the keypad
concerned as "Wireless". This operation makes visible:
• the Enroll button, which allows the start of the enrollment procedure.
• the "Wireless monitoring" section
Pressing the Start button starts the monitoring process on the variation of the signal
transmitted by the device and background noise detected over time.
Type in Code (Installer), PROGRAMMING keypads, ChoosePeripheral "keypad", Wireless
Once the OK button is pressed, it is necessary to work through the menu options and enroll
the keypad.
Programming keypads
Programming of the keypads as peripherals of the Prime system can be performed either via
software or by keypad.
Click-on the Keypads button on the menu on the left, the "Programming" section on the right
will provide two sections.
• Configured keypads, with a list of all the configured keypads. By selecting one of these
items it is possible to set the parameters of the single keypad by clicking on the
• Keypad parameters, section with parameters common to all the keypads.
Type in Code (Installer), PROGRAMMING Keypads, Enablements, ChoosePeripheral
This section provides a list of the available keypads.
Alongside the description of the keypads the following symbols may appear:
• "<", that indicate the keypad in use
• "*", that indicates a keypad configured on the I-BUS
You can select a keypad for parameter programming from this list.
Programming peripherals
Chapter
3-1
3-1-1
Via software
Via keypad
WIRELESS
KEYPADS
Via software
Via keypad
3-1-2
Via software
button.
Via keypad
ChoosePeripheral
KEYP.
001)
KEYP.
002
KEYP.
002
3
*
11
Advertisement
Table of Contents
