Cloud Mode" Preset - INIM Electronics Prime Programming Manual

If you have a dynamic public IP address, you may find it
useful to use a domain name which will allow you to
trace the LAN board at all times.
Prime supports the service offered by:
Domain
• dyndns.org
User name • freedns.afraid.org
• no-ip.com
Password
• camsec.net
• inimdns.biz
By registering at one of these addresses, you will obtain
the access data required in this programming section:
This interval (expressed in seconds) will be applied by
Update every the LAN when updating the association of the selected
domain with the public IP address.
Check DDNS
This button start the DDNS account verification (for
"inimdns.biz" service only).
account
If enabled, the Prime control panel clock will be
synchronized with NTP protocol, therefore, it will be
necessary to indicate:
Enable NTP syn-
• Server
chronization
• Update every - this is the time, expressed in
seconds, that elapses between successive time
updates.
If enabled, the Modbus/IP service on the LAN board will
be activated; in this case it is necessary to indicate:
Enable Modbus
• Port
• Access Codes
This section allows you to program the parameters of the IP connection
test.
IP address
Pv4 Address and port connection attempts are directed
to.
Port
Time, expressed in seconds, between connection tests. If
Interval
"0" is set, the connection test will be disabled.
Number of
Number of connection attempts for each test.
attempts
4-4
Event
Zone alarm
Terminal tamper
Zone bypass
Effective arming mode on parti-
tion
Partition armed in Away mode
Partition disarmed
Overtime request
Partition failed to arm
Thermostat on keypad
Activate scenario
Emergency button
Panic
Open-panel tamper
Dislodged-panel tamper
Zone fuse fault
28
Table 4-4: IP connection

"Cloud mode" preset

In order to make it easier for the installer to program a Prime panel registered with the Inim
Cloud service, the software has an option that, if enabled, provides a preset of some of the
control panel parameters that would otherwise have to be programmed individually.
If activated, the software will perform the following default programming: A preset of events
of various types will be applied and must be communicated to the Cloud when they occur.
Table 4-5: Preset events for the Cloud
Communication to Cloud in case of
Activation Restoral
Yes Yes
Yes Yes
Yes Yes
Yes
Yes
Yes
Yes
Yes
Yes Yes
Yes
Yes
Yes
Yes Yes
Yes Yes
Yes Yes
Event
Reader Tamper
Sounder flasher tamper
Nexus tamper
No Video detector tamper
No Expansion Loss
No Keypad Loss
No Reader Loss
No Sounder/flasher loss
Nexus loss
No Video detector loss
No Jamming
No Low battery wireless zone
Wireless zone loss
Valid Installer code
Invalid code
Centrali anti-intrusione
IP Connection
parameters, DNS
Not available
dynamic
Not available
Not available
IP connection
parameters,
Not available
Configure NTP
client
Connection
parameters,
Not available
Modbus
Not available
IP connection
Not available
parameters, IP
connection test
Not available
parameters
Not available
Communication to Cloud in case of
Activation
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Programming from the Control panel
Restoral
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No