Telephone Line - INIM Electronics Prime Programming Manual

Programming manual
Selection box for the channel on which you can route
the call:
Channel • PSTN
• Nexus
• LAN
This field allows you to select the SIA-IP protocol
encryption type:
• None
• AES 128 bit
Encryption
• AES 192 bit
• AES 256 bit
After selecting the type is is necessary to indicate
the encryption key.
This option allows the telephone number to receive an
Receive SMS SMS message from the Nexus GSM module, as well as
all other event-related communications.
This option, in the event of call failure on a channel,
enables the control panel to carry out call attempts on
Toggle channel
an alternative channel (Nexus) and then retry on the
on call failure
original channel in order to alternate the set number
of attempts.
If a telephone number is configured as "SIA-IP", you
SIA-IP must program the IP address and the SIA-IP receiver
port in this section.
Enable SIA-IP If a telephone number is a "SIA-IP" type number, this
polling option enables the polling function.
You can associate each telephone number with specific
partitions. By selecting the partitions, you can enable/
Partitions disable users (who have at least one of these
partitions in common with the telephone number) to
modify the number concerned.
A key is available that directly accesses the
Failed call
programming section of the failed call.event.
If a telephone number is "SIA-IP" type, the IP address and port of the SIA-IP receiver must be
entered in the receiver number field in the "Number" section, using the following format:
where:
- "xxxyyyzzzttt" are the 4 octets of the IP address (standard IPv4), each of which should be
written with 3 figures and, if necessary, "0" filler characters and no separation points.
- "ppppp" is the port and should be written with 5 figures and, if necessary, "0" filler
characters.
If a telephone number is a "SIA-IP" type number, it is possible to enable the "polling" function.
In this way, from this number the control panel sends a periodic signal to the receiver SIA-IP
server, which can verify proper functioning of the transmission. The parameters of the polling
periodicity are available in the "Telephone parameters" section (Table 11-2: Telephone
parameters).
Some protocols (reporting formats) accept digits only, whilst others accept also "A", "B", "C",
"D", "E" and "F", available using keys

Telephone line

The control panel will engage the telephone line and
Dial-tone check check for the "dial tone"; if present, the control panel
will start dialing.
Pulse dialing The control panel will dial using pulse tone.
If a "telephone line fault" event occurs, the control
Telephone line
panel will flash the respective icon on the keypad
fault alert
displays.
The control panel will override the answerphone
function.
Double call
Option available only for PSTN calls.
Programming the telephone
Table 11-1: Parameters of single telephone number
xxxyyyzzzttt,ppppp
.
Table 11-2: Telephone parameters
Parameter
Telephone, Selected
number, "number", Op-
tions
Not available
Telephone, Selected
number, "number"
Events, Failed call
Software section Installer menu section
Telephone
Parameters
parameters -
Dial tone check
Telephone line
parameters
Pulse dialing
Line down signal
Double call
"SIA-IP" TYPE
POLLING SIA-IP
ACCOUNT CODE
11-2
53