Chapter 16 Events Log - INIM Electronics Prime Programming Manual

16
Chapter
Via software
Number which indicates the chronological order of the
Num.
events in the log.
Date/Time Event date and time
Event Type of event
Filter
Agent Parameters for further event details.
Location
Category Logic grouping of events
Number which indicates the chronological order of the
Num.
events in the log.
Date/Time Event date and time
Button to download the events log from the control panel.
Print button for the events log
Button to save the contents of the events log to the
database.
Button to load the contents of the events log from the
database.
A from-to period will be requested, if no particular period is
specified the entire contents of the Events Log will be
loaded.
Button to delete the Events log from the database.
A from-to period will be requested, if no particular period is
specified the entire contents of the Events Log will be
deleted.
Via keypad
Installer Code
18:23 30/01/2018
KEYP. 001
72
Click-on the Events log button on the menu on the left, the "Programming" section on the
right will allow you to view all the events saved to the control panel log. The lines on the table
show the single events and the columns show the relative data.
Table 16-1: Events log via software
Parameter
Type-in Code (Installer), PROGRAMMING User functions, View
This section allows you to display the event log on the keypad, also through the subdivision of
these:
• Events log - allows you to view all the events saved to the log.
• Alarms log - allows you to view all the events relating to zone/partition alarm and tamper
saved to the log.
• Faults log - allows you to view all the fault events saved to the log.
• Arm/Disarm ops. - allows you to view all the arm/disarm operations saved to the log.
Use key or to scroll the chronological events list. For some events, pressing the
button allows you to view the partition details. For example, the details of an "Arm" command will
show the code and keypad concerned and, if you press the
Events log
You can group the events
into categories by
dragging the header of the
required category to the
grey line above the
columns.
These buttons are active
only when you are working
on a solution or a
database.
In particular, the Save
button is enabled after a
reading from the control
panel.
button, the list of partitions involved.
Centrali anti-intrusione
Software section
Menu bar
Events log