INIM Electronics Prime Programming Manual page 42

Parameter
Detector sensibility:
• PIR: from 1 (least sensitive) to 4 (most
sensitive)
• Air2-FD100:1=0,08 dB/m; 2=0,10 dB/m;
3=0,12 dB/m; 4=0,15 dB/m (default)
PIR detector sensitivity
Varies from 1 (least sensitive) to 10 (most
sensitive). The default setting is 6.
Microwave detector sensitivity.
Varies from 1 (least sensitive) to 10 (most
sensitive). The default setting is 6.
Tamper sensor sensitivity.
Varies from 1 (least sensitive) to 10 (most
sensitive). The default setting is 3.
Anti-mask detector sensitivity
Varies from 1 (least sensitive) to 10 (most
sensitive). The default setting is 3.
Selection of the magnetic reed contact:
• Magnet long side - for detection on the long
side of the magnetic contact.
• Magnet short side - for detection using the
short side of the magnetic contact.
• Both magnets - for detection using both sides
of the magnetic contact.
Shock detector sensitivity
Varies from 1 (least sensitive) to 10 (most
sensitive). The default setting is 1.
Maximum angle within which the movement is not
signalled, from 1 (minimum tilt) to 10 (about 90 °
from the resting position); 1 is the default preset
value.
This parameter allows you to set the delay before
signalling of tilting occurs (seconds or
milliseconds)
Check box to disable the corresponding detector
Clicking on the Real-time button displays the current values of the following
features of the wireless device:
Real-time
Reading level
Battery charge level
Signal reception
RF analysis
42
Table 6-10: Wireless detector sensitivity
Terminal type
Infrared
Smoke detector
Passive infrared detector
Outdoor terminal
Dual technology detector
Curtain detector
Dual technology detector
Curtain detector
Dual technology detector
Curtain detector
Outdoor terminal
Dual technology detector
Curtain detector
Magnetic contact
MC200 magnetic contact
MC200 magnetic contact
MC200 magnetic contact
Passive infrared detector
Outdoor terminal
Dual technology detector
Curtain detector
MC200 magnetic contact
Table 6-11: Real-time for wireless zones
Parameter
The value read by each detector of the device is displayed on
a bar which indicates the alarm threshold by means of a
colour change from green to red.
Percentage of the device battery charge.
This is a series of notches that represent the signal reception
strength on the device as received by the Air2-BS200
transceiver.
This button opens a window which allows you to monitor the
signal variations transmitted by the device and any detected
background noise.
Centrali anti-intrusione
Via software
Sensitivity
Sensitivity
Sensitivity
Sensitivity
Microwave sensitivity
MicrowaveSensit.
Tamper sensitivity
Shock Sensit.
Anti-mask sensitivity
Shock Sensit.
MagnetLongSide
Reed relay type
MagnetShortSide
BothMagnets
Shock sensitivity
Shock Sensit.
Tilt
Tilt
Tilt delay
Tilt duration
Disabled Not available
Software section
Selected terminal
Programming terminals
via keypad