Programming Via Prime/Studio Software - INIM Electronics Prime Programming Manual

EXIT? OK = YES
18:23 30/01/2018
DASIDASI--
2-2
Note
10
3. The system will allow access to installer menu only after the entry of a valid PIN.
Once access to the installer menu is achieved, the system will:
• Block all system keypads except the one you are using.
• Broadcast the "PROGRAMMING" message to all the keypads.
• Force all the system keypads to standby status.
• Bring the call queue and events log to a temporary standstill, thus there will be no events
saved to the log, no outputs activated and no outgoing calls.
To exit the installer menu, press Esc or C until the system asks: "EXIT? OK = YES", therefore
press OK.
Once you exit the installer menu, the control panel will:
• Apply all the new settings and values.
• Restore the I-BUS, reprogramme and make all the peripherals fully operational.
• Restore the call queue, and events log to normal operations.
Programming via Prime/
STUDIO software
For a description of the Prime/STUDIO software and the instructions on how to use it, refer to
the software manual.
Programming of certain parameters (concerning, for example, zones and outputs) via the
Prime/STUDIO software is possible only when the entire project of the system has been
completed.
1. Open a system solution (Open button on menu).
2. First select the element to be programmed using the buttons on the left and then cus-
tomize the programming parameters in the relevant section that appears on the right.
3. Connect your computer to the system.
4. Write the data on the control panel by clicking on the Write button.
If an error occurs during the writing phase, you must repeat the operation. Any data currently on the
control panel will be overwritten.
5. If required, save the solution (Save button) or print the details (Printbutton).
Centrali anti-intrusione
Programming from the Control panel