Updating The Primelan Firmware - INIM Electronics Prime Programming Manual

Field for the insertion KNX telegram, signal from the KNX system corresponding
KNX Event
to an event.
... Button to open the "Add KNX telegram" window.
Actions on control
Check box to indicate the action to be activated on the Prime control panel.
panel
Element /Mode Action parameter.
Execute if bit=0
Execute if bit=1
Options that activate the action on the control panel depending on the bit
associated with the signal from the KNX.
Execute anyway
Execute as a bit
Delete Button to delete the corresponding event from the list
Action
on control
Mode
panel
Away mode
Stay Arm
Arm in Stay
Instant mode
mode
Disarm
Reset
Bypass
Zone bypass
Unbypass
Activation
Activate exit
Deactivation
Activation
Activation
scenario
13-5
Via software
ATTENTION!
68
Table 13-6: Signals from KNX system to Prime control panel
Parameter
The activation of an action in the Prime control panel triggered by a signal from a KNX system
depends on the value of the bit that accompanies each telegram and on the selection of one of
the "execute" parameters indicated above. Following is an explanatory table:
Table 13-7: Actions on control panel from KNX system
Execute if bit=0
bit=0 bit=1 bit=0
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Activation
No action
action
Updating the PrimeLAN
firmware
Through a direct connection between the Prime/STUDIO software and the Prime control panel,
it is possible to update the control panel firmware to the latest revision available at moment of
the software release.
Click-on the Firmware upgrade button on the menu on the left, the "Programming" section
will show the buttons for the updating procedure.
Click-on the PrimeLAN board button. A section will open with the available updates and the
Start procedure button.
In order to avoid invalidating the procedure, do not switch off or disconnect the PC or Prime
control panel during the updating process.
Execute if bit=1
bit=1 bit=0
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Activation Activation
No action
action
Centrali anti-intrusione
Software section
Execute anyway Execute as a bit
bit=1 bit=0
Activation Activation
action action "Disarm"
Activation Activation
action action "Disarm"
Activation Activation
action action "Disarm"
Activation
No action
action action
Activation
No action
action action
Activation Activation
action action "Unbypass"
Activation Activation
action action "Bypass"
Activation
Activation
"Deactiva-
action action
tion"
Activation Activation
action action "Activation"
Activation
No action
action action
Programming the PrimeLAN board
Programming
KNX, From KNX to
control panel
bit=1
Activation
action
Activation
action
Activation
action
Activation
action
Activation
action
Activation
action
Activation
action
Activation
action
Activation
action
Activation
action