Monitoring Sounder/Flashers - INIM Electronics Prime Programming Manual

Anti-intrusion control panels and security systems

Table of Contents

Programming manual

This section is further divided into several sub-section in accordance with the type of

peripheral.

The Update button (bottom right) provides details of each peripheral:

• tooltips provide information regarding the peripheral model and whether it is present in the

configuration or not

• the address, firmware version and operating voltage of each of the peripherals present is

shown alongside the icon

Monitoring of the Nexus communicator requires a further selection achieved by ticking the

respective check box.

The "Peripheral details" section provides the sub-section for wireless devices, selectable via

the label. This section, after clicking-on the Update button, shows a list of all the wireless

devices connected to the control panel.

The monitoring-operation provides the following feedback for each device:

• an index of the reception quality of the wireless signal

• the percentage of the battery charge

The colour of the values shown also indicates the level of both the signal index and the charge

(red-orange-green).

Monitoring sounder/flashers

The monitoring phase on the sounder/flashers, both wireless and on the I-BUS, provides

feedback relating to the status sounder/flashers and their descriptions.

Click-on the Monitoring button on the menu bar, then go to the "Programming, Sounder/

flashers" section.

The information relative to each sounder/flasher is shown after the respective icon. If the

sounder/flasher is configured the icon will not be blanked out and will be accompanied by its

description and the status, fault and tamper icons, as follows: