INIM Electronics Prime Programming Manual page 12

KEYPAD SETTINGS
3-1-3
If a wrong code is typed-in at a keypad more than 5
times in succession, the keypad will lock for 10
minutes.
Wrong PIN key-
pad lockout
If you reset the control panel or access programming
while the keypad-lockout time is running, it will
refresh to zero and start again.
The keypad will show the descriptions of any open
zones (zones which are not in standby status) when
the partitions disarm.
View open zones
Any autobypassable open-zones will be shown in
white on a black background.
The second line on the keypad displays will show the
Show scenario
description of the active scenario.
This refers to the number of times messages relating
Message repeti- to the events are played vocally on the keypad (only
for keypads with speakers).
tions on voice
keypad The playback phase can be stopped by pressing any
button.
If this option is enabled, message playback can be
Press any key to
interrupted solely by pressing a button on the
end playback
keypad.
Description of the keypad (to be customized by the
Description
installer).
Check box for the selection of the keypad type:
• Keypad with display and keys
Keypad type
• Touch-screen keypad
• Wireless keypad
Section for the selection of the partitions the keypad
Partitions
can operate on.
For each key, from F1 to F12, you can program the
shortcut type which can be selected from among all
the available shortcuts.
Shortcuts
When programming an Alien keypad, positions F1 -
F12 refer to the positions in the list available in the
"Scenarios" section of the Alien keypad you are
working on.
You must specify a further parameter for each
shortcut:
• Arm/Disarm - the parameter this shortcut refers
to will be one of the scenarios.
Shortcut param-
• Activate output - the parameter this shortcut
refers to will be one of the scenarios.
eter
• Deactivate output - the parameter this shortcut
refers to will be one of the scenarios.
• Panic - the parameter this shortcut refers to will
be one of the scenarios.
Shortcut options
If this option is enabled and a user selects the
shortcut (by pressing the relative function key), the
system will request entry of a user code before the
Requires code
activating the shortcut in question. If the system
recognizes the entered user code, it will activate the
shortcut command.
12
The keypads of the Prime system also provide a section where you can set their parameters,
for the customization and optimization of their use.
The complete description of the parameters in this section can be found in paragraph 6-6-8
Keypad settings in the user manual.
Keypad parameters
Table 3-1: Parameters common to all keypads
Parameter
Table 3-2: Parameters for single keypads
Parameter
Software section Installer menu section
Keypad parameters
Parameters,
Parameters, Other pa-
rameters,
Software section Installer menu section
Configured keypads ,
Keypads, ChoosePeriph-
selected keypad
eral, "keypad"
Not available
Configured keypads ,
selected keypad,
Keypads, ChoosePeriph-
General
eral, "keypad"
Configured keypads ,
Keypads, ChoosePeriph-
selected keypad,
eral, "keypad",
General, Advanced
Shortcut Func.keys,
"Fx", Options
Centrali anti-intrusione
Keypad lockout
View open zones
Show scenario
LocKpadMessTimes
LocKpadMessTimes,
"255"
F1/4KeyShortcuts
Shortcut Func.keys,
"Fx", Type
Requires code
Programming peripherals