Monitoring Terminals; Monitoring Timer; Monitoring Peripheral And Wireless Devices - INIM Electronics Prime Programming Manual

21-3
Via software
Via keypad
21-4
Via software
21-5
Via software
PERIPHERALS
84
If necessary, these icons also report the alarm or tamper status of one of their zones showing
the appropriate icon (refer to paragraph 21-3 Monitoring terminals).
By clicking on one of the partition icons, in the "Controls" section you can view the status of
the partition, its status, tamper conditions and whether the "auto-arm" function has been
enabled (refer to paragraph 5-1 Partition parameters).
The "Actions" section is also available where, once a valid user code has been entered, it is
possible to change the arming status of the partition or carry out reset.

Monitoring terminals

Click-on the Monitoring button on the menu bar, then go to the "Programming, terminals"
section.
On selecting a partition from the section at the top, the section will divide into two parts:
• the left side will show the list of all the zones of the selected partition
• the right side will show the list of all the system outputs
Both sections will show the status of the items listed according to the icons present:
Icon
Zone operating normally and in stand-by
status
Zone in alarm status
Zone with alarm memory
Zone tamper in progress
Zone with tamper memory
The lists also provide a button to enable or disable the related zone, as well as a button to
activate or deactivate the related output. These operations are allowed only after entry of a
valid user code authorized to carry out these operations.
Type-in Code (Installer) , PROGRAMMING User functions, View, Zone status

Monitoring timer

Click-on the Monitoring button on the menu bar, then go to the "Programming, Timer"
section.
This section provides a grid containing all the available timer icons.
The status of each icon reflects the status of the respective timer and indicates, in real-time,
whether it is enabled or not, or whether it is currently On (operating).
Monitoring peripheral and
wireless devices
The Prime/STUDIO software provides various sections for the monitoring of wireless devices
and I-BUS connected devices, selectable by means of the headers at the top, in each of them
the peripherals are represented by icons.
Click-on the Monitoring button on the menu bar, then go to the "Programming, Peripherals,
Peripheral details" section.
This section shows which keypads, readers and expansion boards, of those available, are
included in the configuration and which of theses are present or in tamper status.
Table 21-2: Terminal status icons
Status
Centrali anti-intrusione
Icon Status
Zone in test mode.
Zone disabled
Output activated
Output deactivated
Monitoring the control panel