Table of Contents
Advertisement
11
Chapter
ATS DEVICE
Via software
Via keypad
11-1
This is an editable field for the code user's telephone
Description
number, to be customized by the installer.
Editable field for the contact number (maximum 20
Telephone num-
digits).
ber
Accepts also "," (= 2 second pause), "*" and "#".
Telephone number type:
•
None - the selected number can receive SMS text
messages only
•
Voice - the selected number can receive voice
calls and SMS text messages
Type
If the number refers to the Alarm Receiving Centre,
assigns the ARC protocol (reporting format):
•
Ademco 10bps, Ademco 14bps, Franklin 20bps,
Radionics 40bps, Scantronic 10bps, CONTACT-ID,
Ademco Express, SIA-IP
This is the 4-character alphanumeric code which
Account code
identifies the caller in reports to the Alarm Receiving
Centre.
52
Programming the telephone
The Prime system provides for the programming of all the telephone parameters, both for the
telephone numbers to be called when events occur, and for the telephone line parameters.
The built-in ATS device (alarm transmitting system) provides the following features (in
compliance with EN50131 relating to the notification of information).
• Type B notification apparatus (refer to EN50131-1:2008-02, paragraph 8.6 Notification,
Table 10, page 46, Grade 2).
• The ATS2 notification apparatus specified in the table, is characterized by:
•• Transmission time - classification D2 (60 seconds)
•• Transmission time - max. values M2 (120 seconds)
•• Classification time - classification T2 (25 hours)
•• Substitution security - S0 (no detection of device substitution)
•• Information security - I0 (no detection of message substitution)
Click-on the Telephone button on the menu on the left, the "Programming" section provides
two sections.
• Telephone numbers, where all the available telephone numbers and their parameters
are listed. Selecting one of these items allows you to set the parameters of the single
scenario by clicking on the
• Telephone parameters, where it is possible to set the parameters of the telephone line
and telephone dialers.
Type-in Code (Installer PIN) , PROGRAMMING Telephone
In this section it is possible to program both the parameters of each selected telephone
number and some parameters of the telephone line. Other parameters are available in the
sections:
Type-in Code (Installer), PROGRAMMING Parameters or also Other parameters
Telephone numbers
Table 11-1: Parameters of single telephone number
Parameter
button.
Software section
Telephone
numbers, selected
number
Centrali anti-intrusione
Installer menu section
Telephone, Selected
number, "number"
Programming the telephone
Advertisement
Table of Contents
