Table of Contents
Advertisement
If this option is enabled, the code concerned can
change the parameters only of codes of a lower level
in the code hierarchy whose partitions are a subset of
its own partitions.
For example, if a code is configured as "Master" with
Partition filter
"Partition filter" and is assigned to partitions 1, 3, 5
and 7, it will be able to enable/disable or change the
PIN of a "User" code assigned to partitions 1 and 5 but
not the PIN of a "User" code assigned to partitions 1,
2, and 3.
If this option is enabled, after entering a valid PIN and
without pressing OK, the user of the code concerned
can activate the shortcut associated with theF12 key,
programmed through the "Shortcuts activated by
function keys" (refer to paragraph 9-3 User code
parameters).
Fixed length
If this shortcut is number 1 ("Arm/disarm") and all the
partitions assigned to the user code in question are
disarmed, the command will arm them, otherwise it
will disarm them.
If this option is enabled, the user of the code
concerned can access their menu only after pressing
OK and typing-in their PIN.
If enabled on a keypad with a speaker, the voice guide
(after PIN entry followed by OK) will announce the
Voice guide
shortcut descriptions relating to the entered user-code
and the respective number keys on the keypad.
If enabled, the code will be able to disable the system
Patrol
for the pre-set "Patrol time".
If enabled, the code PIN can be used to operate the
system from any remote telephone.
If the code PIN is entered on a remote telephone
keypad, only the shortcuts associated with keys 0 to 9
can be used to:
•
Arm/Disarm
Remote access
•
Stop alarms
•
Clear call queue
•
Delete memory
•
Activate output
•
Deactivate output
•
Listen-in
•
Partition status
A key is available that directly accesses the
Recognized valid
programming section of the system arming event of
user code
the selected code.
This section allows you to enable/disable access to the
various sections of the User Menu.
Enablements
For details regarding the sections of the user menu,
refer to theUser Manual.
This section allows you to enable/disable each output
Enablement of
the code is authorized to control manually via the user
outputs
menu.
This section allows you to assign a shortcut to each of
Shortcuts acti-
the function keys F1, ... , F12), with the eventual
vated via func-
respective parameter, which will activate when the key
tion keys
is pressed.
This section allows you to assign a shortcut to each of
Shortcuts acti-
the number keys (0, ... , 9) on the control-panel
vated by internal
keypad (with the eventual respective parameter)
keys
which will activate when the key is pressed.
This section allows you to assign a timer to the code.
Timers
The code will be operative only at the pre-set times.
48
Table 9-2: Single code parameters
Table 9-3: Code enablements
Parameter
Codes, "code", Op-
tions,
Codes, selected
code, Option
details
Codes, selected
Events, Valid Code
code
Software section
Installer menu section
Codes, selected
Codes, "code",
code, Enablement
details
Codes, selected
code, Shortcut
details
Codes, selected
code, Option
details
Centrali anti-intrusione
AnnounceShortcut
Enablements
Assigned outputs
ShortcutFunc.Key
0/9 Key shortcuts
Timers
Programming user codes
Advertisement
Table of Contents
