Programming A Single Voice Message; Voice Board Maintenance - INIM Electronics Prime Programming Manual

14-1
Nr. Message index inside the voice board memory.
Description This is an editable field for the message description.
Type of coding for the message:
• No Message - no recording or playback
Type of coding • High quality - for superior recording/playback quality
• Average quality - for good recording/playback quality (similar to phone-
line quality).
Quality Check box for the recording quality of the associated audio file.
Time This is the duration of the associated audio file (expressed in seconds).
Text to speech Text of the associated audio file.
Message category This is the message type the selected message belongs to.
Note This field allows you to edit the text you wish to associate with the message.
This section provides software for the playback and recording of audio files.
This software allows you to edit the audio file associated with the message
and:
Recorder • Load an audio file (.wav)
• Play the loaded audio file
• Record a new audio file
• Reset the selected file to default
Good/Average
Button for the selection of the sound quality of the audio file.
Quality
This section allows you to edit the text which will be converted to an audio
file and associated with the message.
Text to speech
The conversion and association with the message will occur after the
execution of text to speech (in this section this can be done using the record
button).
Via keypad
14-2
Read all messages from Button that allows the reading from the control panel of all the messages
the control panel on the voice board.
Write all messages on Button that allows the writing on the control panel of all the programmed
the control panel voice messages.
Check SmartLogos Button to start a check on the voice board and obtain information
board regarding its firmware version.
Button to start the formatting process of the voice board in order to align
the firmware version with that of the control panel.
Formatting the voice
The following formatting options are available:
board
•
•
70
Programming a single voice
message
Table 14-2: Voice message parameters via software
Parameter
Type-in Code (Installer), PROGRAMMING Messages, "message", Record
Before recording a voice message, you must first select:
• No Message - no recording or playback
• High quality - for superior recording/playback quality
• Average quality - for good recording/playback quality (similar to phone-line quality).
High quality messages occupy twice the memory space of average quality messages of the
same length.
The recording phase will start when the OK button is pressed, the recording time (in seconds)
will be indicated by a second counter on the display. If you wish to stop the record/playback
operation manually press OK, otherwise, it will end automatically when the pre-set time
expires.
Type-in Code (Installer), PROGRAMMING Messages, "message", Play
Message playback section. You can adjust the volume during the playback phase using keys
and .
Type-in Code (Installer), PROGRAMMING Messages, "message", Delete
Delete message section. The control panel will ask for confirmation before deleting the
message by means of the OK button.

Voice board maintenance

Table 14-3: Voice board maintenance operations
Parameter
Preserve previously-recorded messages
Format using default messages
Centrali anti-intrusione
Software section
Messages list
Messages list, selected
message
Software section
Voice board
maintenance
Voice board
maintenance,
Formatting the
SmartLogos board
Voice messages