Programming The Nexus - INIM Electronics Prime Programming Manual

3-4-4
•
•
•
•
Description
•
•
•
•
This is the audible signal the sounder will emit. To be selected from the 5
Tone
available tones.
This is the sounder activation time, expressed in seconds (from 1 to 127) or
Time
minutes (from 1 to 127)
Volume Sound level of the sounder/flasher.
•
•
Flash type
•
•
This is the flasher activation time, expressed in seconds (from 1 to 127) or
minutes (from 1 to 127).
Time
If the event which activates the flasher indefinitely is a zone alarm, terminal
tamper, partition alarm or partition tamper event, even memory reset
operations will switch off the flasher.
Activate sounder Enable/Disable sounder activation
Activate flasher Enable/Disable flasher activation
Activate STATUS LED Enable/Disable activation of the STATUS LED
Activate PRG LED Enable/Disable activation of PRG LED
Activate TAMPER out-
Enable/Disable activation of TAMPER output
put
Activate FAULT output Enable/Disable activation of FAULT output
Test
Buttons to start and stop a test on the pattern selected via the audio output of
your PC and the image of the sounder/flasher on the left of the buttons.
Stop
Test pattern on
sounder/flasher
Button to reset the factory default pattern
3-5
Via software
Note
20
Programming the patterns
Table 3-10: Pattern parameters
Parameter
Burglary
Burglary low volume
Fire
Tamper
Selection menu of the pattern to be programmed.
Pre-alarm
Automation
Squawk
Chime
36 flash/min
46 flash/min Dropdown box for the selection of the flash rate
56 flash/min (number of flashes per minute).
ON solid
Test Buttons to start and stop a test on the selected
pattern on the sounder/flasher selected from the list
provided.
Stop
This test requires an active connection with the
control panel.

Programming the Nexus

The Nexus programming phase allows you to select which actions the control panel will
implement on receiving a voice call/SMS message (from an authorized user) over the GSM
network. Each command comprises a group of fully-programmable parameters.
Each time a user requests an operation - via a correctly formatted SMS message or voice call
to the SIM card of the Nexus - the control panel will activate the respective shortcut/event
and send confirmation (feedback) of the successfully implemented command.
The following parameters can be programmed solely via the PrimeSTUDIO software. Click-on
the Nexus button on the menu on the left, then go to the "Programming" section on the right
to set the respective parameters.
INIM does not guarantee the total availability of all the GSM/GPRS functions described in this manual,
due to the various combinations of GSM/GPRS service providers, SIM types and telephone models that
may be in use.
Centrali anti-intrusione
Software section
Sounder/flasher
pattern
Bar for the section
menus
Programming peripherals