Table of Contents
Advertisement
3-5-5
Access point name
This is the field for the name of the GPRS provider.
(APN)
This button opens a window for the user's name and password, sometimes required
Advanced
by the provider. If these details are not required, theses fields can be left blank.
Note
3-6
Via software
Key
Read
Button for reading from the control panel and writing on the control panel the data relative the
configuration of the wireless transceivers.
Clicking-on this button opens the "Wireless" window where you can select the transceivers from those
configured.
Write
This button starts the guided cloning process for the wireless keys enrolled by the transceiver of the
Clone remote-
selected reader.
control keys
The guide allows you to indicate which transceiver, from those selectable, the cloned keys will be assigned to.
This button starts an operation which attenuates (6db) the wireless signal transmitted by the transceivers for 5 minutes.
RF
During this period the installer can carry out tests on the stability of the RF connection under weak-signal conditions.
3-6-1
Section for the selection of the wireless
communication channel to be used by the transceiver
that simulates the reader undergoing programming:
Channel
•
Channel 001, 868.1MHz
•
Channel 002, 868.3MHz
•
Channel 003, 868.5MHz
Disable tamper
This option disables the Air2-BS200 transceiver
protection
tamper signal.
This option disables the rolling code algorithm for the
transmission of wireless commands via the Air2-
BS200 transceiver module.
Disable the Roll-
ing Code
Deactivation can be useful to the installer when the
same wireless command device is used on several
systems.
24
GPRS connection parameters
The "Programming - GPRS Parameters" section provides the parameters necessary for setting
up the GPRS connection for the remote GPRS connection with the control panel.
Table 3-14: GPRS parameters
Parameter
These parameters are valid only when the control panel is equipped with a Nexus model with data
transmission (Nexus/G, Nexus/3GU or Nexus/3GP).
Wireless transceivers
The Prime/STUDIO software has a section that allows you to view all the enrolled wireless
devices and also set up the programming parameters of each single Air2-BS200 transceiver.
Click-on the Wireless transceivers button on the menu on the left, the "Programming"
section on the right will show a template for each configured transceiver.
Each sub-section shows:
• the transceiver model
• the firmware version of the transceiver board
• the transceiver parameters
• a list of devices enrolled by the transceiver;
for each device it shows:
-
the Icon
-
the terminals (where present)
-
the serial number
-
the model
Table 3-15: Menu bar for wireless transceivers
Programming transceivers
Table 3-16: Wireless transceiver parameters
Parameter
Function
Software section
Wireless
transceivers,
Wireless
Centrali anti-intrusione
Software section
GPRS
parameters
Installer menu section
Readers, ChoosePeriph-
eral, "reader", Channel
Readers, ChoosePeriph-
eral, "reader", Op-
tions, Disable Tamper
Readers, ChoosePeriph-
eral, "reader", Op-
tions, RollingCodeDisab
Programming peripherals
Advertisement
Table of Contents
