INIM Electronics Prime Programming Manual page 15

Programming manual
Type-in Code (Installer PIN) , PROGRAMMING Readers , ChoosePeripheral
In the list of configured readers, the reader simulated by an Air2-BS200 has a"W" at the end
of its description.
Programming readers
The programming of readers as peripherals of the Prime system can be carried out either via
software or from a keypad.
Click-on the Proximity readers button on the menu on the left, the "Programming" section
on the right will provide two sections:
• Configured readers, with the list of all the configured readers. Selecting one of these
items allows you to set the parameters of the single reader by clicking on the
• Reader parameters, section with parameters common to all the readers.
Type in Code (Installer), PROGRAMMING Readers, Enablements, ChoosePeripheral
This section allows you to program the various options of the selected reader.
Reader parameters
No reader buzzers will emit audible signals during
Reader Buzzers
running entry time, exit time, output time or pre-arm
OFF
time.
Programming the
This section allows you to program the addresses of
proximity reader
the proximity readers.
address
LED codes of the
This section allows you to view how the addresses are
addresses displayed on the LEDs.
This is the name used to identify the reader,
Description
customizable by the installer.
Section for the selection of the partitions the reader can
Partitions
operate on.
You can assign a shortcut to each of the LEDs,
selectable from those available:
• None
• Arm/Disarm
• Stop alarms
• Clear call queue
Type
• Delete memory
• Activate output
• Deactivate output
• Overtime
• Teleservice request
• View faults
You must specify a further parameter for each shortcut:
• Arm/Disarm - this parameter refers to one of the
available scenarios
• Activate output - the parameter this shortcut
Parameter refers to will be one of the scenarios.
• Deactivate output - the parameter this shortcut
refers to will be one of the scenarios.
• Panic - this parameter will be one of the 15 panic
events
Valid key at
This button accesses directly the programming section
of the "Valid key at reader" event
reader
In the case of a reader simulated by the Air2-BS200 transceiver, the parameters of the
wireless system are available in the section reserved for wireless receivers (refer to paragraph
3-6 Wireless transceivers)..
Programming peripherals
Table 3-4: Parameters common to all readers
Parameter
Table 3-5: Parameters of single reader
Parameter
button.
Software section Installer menu section
Reader
Parameters, Reader-
parameters
BuzzersOFF
Readers, Prog. address
Not available
Software section Installer menu section
Configured
readers, selected
Readers, Chooseperiph-
reader
eral, "reader"
Configured
Readers, Chooseperiph-
readers, selected
eral, "reader", Short-
reader, Shortcut
cut, Type
Configured
Events, Valid-
readers, selected
KeyAtReader
reader
Via keypad
3-2-2
Via software
Via keypad
3-2-3
15