INIM Electronics Prime Programming Manual page 66

Buttons for the addition of a new camera or for the deletion of the selected
camera.
Include Security This option, if enabled, includes the "Security Header" in the SOAP messages for
the communication with Onvif devices.
Header in messages
Description This is the description of the selected camera.
IP address
Port
Parameter that permits access to the selected camera.
User name
Password
https If selected, a secure HTTPS connection will be used.
Field for the selection of one of the multimedia profiles of the camera. These
profiles are listed following a read operation requested by pressing the
button.
The
Multimedial profile
can edit the "Token" and name of each one.
The window provides two buttons:
•
•
This field indicates whether the selected camera is equipped with PTZ (Pan, Tilt,
Pan - Tilt - Zoom
Zoom) capabilities.
This section lists all the presets relating to the profile selected in the previously
mentioned programming field. These presets are listed following a read operation
requested by pressing the
The
Preset available for
can edit the "Token" and name of each one.
the selected profile
The window provides two buttons:
•
•
This field allows you to view the addresses (URIs) of frames shots and audio/
URI Snapshot
video streams. These addresses are listed following read operation requested by
URI Stream
pressing the
This is the time that must elapse between two successive frame shots (max. 60
Sampling frequency
seconds).
Number of frames
This is the number of frames (from 0 to 5) which will be saved to the memory
before/after the occurrence of the event the camera is associated with.
pre/post event
The image in the lower part of the section reproduces the instant frame of the
camera selected after pressing the
Images
Clicking on the image itself opens window for the viewing of video footage in
real-time, control of the camera functions and display of the available presets.
66
The PrimeLAN board offers the support for JPEG and MJPEG streaming for surveillance
cameras, viewable as a full video or snapshot. Interaction with ONVIF cameras allows viewing
of recorded images (videos and snapshots) previous to and after the occurrence of an event.
The frames are sent as attachments to emails associated with events or are stored for viewing
using a web interface or AlienMobile application, through the "Camera" section.
To do this it is necessary to:
• program the ONVIF camera (using its own presets), provide it with the ZTL presets
necessary for viewing the zone under surveillance and recorded video
• associate a camera with the occurrence (activation or restoral) of an event through the
Email configuration section (refer to paragraph 13-1 Programming e-mails)
• activate the Record on SD option (refer to paragraph 13-1 Programming e-mails) for the
viewing of recorded frames through a web interface
• using the Prime/STUDIO software, configure the ONVIF camera by clicking-on the
PrimeLAN settings button and then going to the"Programming - ONVIF camera
management" section on the right.
This section provides a pane containing the list of the configured cameras. At the side of this is
another section containing the parameters relative to the selected camera:
Table 13-3: ONVIF camera parameters
Parameter
button opens a window showing all the available profiles and where you
- for manual entry of a profile in the list
- for deletion of the selected profile
button.
button opens a window showing all the available presets and where you
- for manual entry of a preset in the list
- for deletion of the selected preset
button.
button.
Centrali anti-intrusione
Software section
ONVIF camera
management
ONVIF camera
management,
Camera
Programming the PrimeLAN board