List Of Block Start Data - Mitsubishi Electric MELSEC-LD77MS2 User Manual

5.4 List of block start data

2nd point
1st point
Setting item
b15 b8 b7
Da.11 Shape
b15 b8 b7
Da.13 Special start instruction
2nd point
1st point
Setting item
b15 b8 b7
Da.11 Shape
b15 b8 b7
Da.13 Special start instruction
The illustrations below show the organization of the block start data stored in the buffer
memory of Simple Motion module. The block start data setting items
are explained in the pages that follow.
• LD77MS2/ LD77MS4
50th point
Setting item
Setting item
Buffer memory
address
b0
26000+1000n
Da.12 Start data No.
b0
26050+1000n
Da.14 Parameter
n: Axis No.-1
• LD77MS16
50th point
Setting item
Setting item
Buffer memory
address
b0
22000+400n
Da.12 Start data No.
b0
22050+400n
Da.14 Parameter
n: Axis No.-1
Chapter 5 Data Used for Positioning Control
Buffer memory
address
Buffer memory
address
26049+1000n
26001+1000n
26099+1000n
26051+1000n
Buffer memory
address
Buffer memory
address
22049+400n
22001+400n
22099+400n
22051+400n
5 - 99
Da.11
Up to 50 block start data points can be set
(stored) for each axis in the buffer memory
addresses shown on the left.
Items in a single unit of block start data are
shown included in a bold frame.
Each axis has five start blocks (block Nos.
0 to 4).
(Note): For information on the organization
of the buffer memory addresses
assigned to the start blocks 1 to 4,
refer to Appendix 1 "List of buffer
memory addresses".
Up to 50 block start data points can be set
(stored) for each axis in the buffer memory
addresses shown on the left.
Items in a single unit of block start data are
shown included in a bold frame.
Each axis has five start blocks (block Nos.
0 to 4).
Start block 2 to 4 are not allocated to buffer
memory.
Set with GX Works2.
(Note): For information on the organization
of the buffer memory addresses
assigned to the start block 1, refer
to Appendix 1 "List of buffer memory
addresses".
to
Da.14