Mitsubishi Electric MELSEC-LD77MS2 User Manual page 757

[2] Step mode
[3] Step start information
Stop status in the step
operation
1 step of positioning
stopped normally
Standby
Stopped
Interpolation
JOG operation
Manual pulse generator operation
Analyzing
Special start standby
OPR
Position control
Speed control
Speed control in speed-position switching control
Position control in speed-position switching control
Speed control in position-speed switching control
Position control in position-speed switching control
Synchronous control
Control mode switch
Speed control
Torque control
Continuous operation to torque control
In step operations, the timing for stopping the control can be set. This is called
the "step mode". (The "step mode" is set in the control data "
The following shows the two types of "step mode" functions.
(1) Deceleration unit step
The operation stops at positioning data requiring automatic deceleration. (A
normal operation will be carried out until the positioning data requiring
automatic deceleration is found. Once found, that positioning data will be
executed, and the operation will then automatically decelerate and stop.)
(2) Data No. unit step
The operation automatically decelerates and stops for each positioning
data. (Even in continuous path control, an automatic deceleration and stop
will be forcibly carried out.)
Control stopped by a step operation can be continued by setting "step continues"
(to continue the control) in the "step start information". (The "step start
information" is set in the control data "
The following table shows the results of starts using the "step start information"
during step operation.
Axis operation
Md.26
status
Step standby
The warning "Step not possible" (warning code: 511) will occur if the "
" is as shown below or the step valid flag is OFF when step start
operation status
information is set.
Axis operation status
Md.26
Cd.36
Step start
Cd.36
information
1: Continues step
operation
13 - 67
Chapter 13 Control Sub Functions
Cd.34
".)
Step start information
Step start results
The next positioning data is executed.
Step start results
Step not continued by warning
".)
Step mode
Axis
Md.26