Mitsubishi Electric MELSEC-LD77MS2 User Manual page 284

Storage item
Last executed positioning data
Md.46
No.
Positioning data being
Md.47
executed
Deceleration start flag
Md.48

This area stores the positioning data No. attached to the positioning data that was
executed last time.

The value is retained until a new positioning operation is executed.

This area stores "0" when the JOG/inching operation is executed.
Refresh cycle: Immediate

The addresses shown to the right store details of the positioning data currently
being executed (positioning data No. given by
Refresh cycle: Immediate

"1" is stored when the constant speed status or acceleration status switches to
the deceleration status during position control whose operation pattern is
"Positioning complete".

"0" is stored at the next operation start or manual pulse generator operation
enable.
Refresh cycle: Immediate
POINT
This parameter is possible to monitor when "
valid.
5 - 144
Chapter 5 Data Used for Positioning Control
Storage details
).
Md.44
Deceleration start flag valid
Cd.41
" is