Mitsubishi Electric MELSEC-LD77MS2 User Manual page 523

Restrictions
(1) 2-axis circular interpolation control cannot be set in the following cases.

When "degree" is set in "
 When the units set in "
interpolation axis. ("mm" and "inch" combinations are possible.)

When "reference axis speed" is set in "
"
method
(2) An error will occur and the positioning start will not be possible in the following
cases. The machine will immediately stop if the error is detected during
positioning control.
 When the radius exceeds "536870912 (=2
which circular interpolation control is possible is "536870912 (=2
... The error "Outside radius range" (error code: 544) will occur at
positioning start.
 When the center point address is outside the range of "–2147483648 (–2
2147483647 (2
... The error "Sub point setting error" (error code: 525) will occur at
positioning start.

When the start point address is the same as the end point address
... The error "End point setting error" (error code: 526) will occur.
 When the start point address is the same as the sub point address
... The error "Sub point setting error" (error code: 525) will occur.
 When the end point address is the same as the sub point address
... The error "Sub point setting error" (error code: 525) will occur.
 When the start point address, sub point address, and end point address are in
a straight line
... The error "Sub point setting error" (error code: 525) will occur.
Unit setting
Pr.1
Unit setting
Pr.1
31
–1)"
9 - 63
Chapter 9 Major Positioning Control
"
" are different for the reference axis and
Interpolation speed designation
Pr.20
29
)". (The maximum radius for
29
)"
31
) to