4.1 Outline of installation, wiring and maintenance
4.1.1 Installation, wiring and maintenance procedures
Module mounting
Mount the LD77MS to PLC CPU module.
Wiring
Connect external devices to the LD77MS.
Checking wiring
Check wiring with GX Works2.
Parameter setting and auto refresh setting
Perform each setting with GX Works2.
Programming and debugging
Create and debug sequence programs.
The outline and procedures for Simple Motion module installation, wiring and
maintenance are shown below.
Start
Perform parameter
and data setting with
GX Works2?
YES
Start operation
Maintenance
End
Chapter 4 Installation, Wiring and Maintenance of the Product
Refer to Section 4.2 "Installation".
Refer to Section 4.3 "Wiring".
Refer to Section 4.4 "Confirming the installation and wiring".
NO
Refer to the "Simple Motion Module Setting Tool Help" of
GX Works2.
Refer to Chapter 6 "Sequence Program Used for
Refer to Section 4.5 "Maintenance".
4 - 2
Positioning Control".