Mitsubishi Electric MELSEC-LD77MS2 User Manual page 808

Setting item
External input
signal operation
Cd.44
device
: Refer to Section 5.7 "List of control data" for details on the setting details.
(1) When "1: External input signal of servo amplifier" is set, set the Pin No. of
external input signal of servo amplifier shown in the following table.
At MR-JE-B use, refer to Appendix 6.5 "Connection with MR-JE-B".
:
Pin No.
CN3-19 (DI3)
CN3-12 (DI2)
Servo
amplifier
CN3-2 (DI1)
Buffer memory
1: Refer to the "Servo Amplifier Instruction Manual" for details on the pin No.
of servo amplifier.
2: The stop signal cannot be input from the external input signal of servo
amplifier. To input the stop signal, set "[Cd.44] External input signal
operation device". For setting details, refer to Section 5.7.1 "System control
data".
(2) When "2: Buffer memory of LD77MS" is set, use the following control data to
operate the external input signal (upper/lower limit signal, near-point dog
signal and stop signal).
Setting
value
Set the status of the upper/lower limit signal, the
near-point dog signal and the stop signal.
*1
Signal name
DOG
RLS
FLS
*2
STOP
Setting details
14 - 10
Chapter 14 Common Functions
Buffer memory address
LD77MS2
LD77MS16
LD77MS4
1928
5928
to
5931