Configuring The Windrower; Setting The Header Knife Speed; Setting The Knife Overload Speed - MacDon M155E4 Unloading And Assembly Instructions

5.3 Configuring the Windrower

The windrower can be configured to meet changing crop conditions, activate newly added options, indicate a
change of header type, or increase operator comfort level.

5.3.1 Setting the Header Knife Speed

This topic does not apply to rotary disc headers.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
•
The current knife speed is displayed on the
lower line.
4. Press left (B) or right (C) arrows to select knife speed.
Press SELECT (D).
5. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.

5.3.2 Setting the Knife Overload Speed

This topic does not apply to rotary disc headers.
NOTE:
•
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
The recommended knife overload speed is 75% of knife speed.
214738
CAB DISPLAY MODULE (CDM)
Figure 5.17: CDM Programming Buttons
Figure 5.18: Knife Speed
59
Revision A