Table of Contents
Advertisement
3. Press SELECT (B) until CAB DISPLAY SETUP? appears on the
upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? will appear on the upper line.
5. Press SELECT (D) until DISPLAY CONTRAST appears on the
upper line.
• The current setting will appear on the lower line.
6. Press the left (B) or the right (C) arrow to adjust the CDM's
contrast setting.
7. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next CAB DISPLAY SETUP?
option.
3.19.8 Configuring Windrower
The Operator can configure several windrower, header, and other attachment performance options using the cab display
module (CDM).
Setting Header Knife Speed
The speed of the knife on non-rotary headers can be set by accessing the cab display module's (CDM) SET KNIFE SPEED
sub-menu, in the WINDROWER SETUP menu.
NOTE:
The header MUST be physically attached and hydraulically and electrically connected to the windrower before the
Operator can perform this procedure. The CDM automatically adjusts its programming for each header. For more
information, refer to
4.5 Attaching and Detaching Headers, page
215676
OPERATOR'S STATION
MXXX
Figure 3.76: Cab Display Setup
MXXX
A
Figure 3.77: Display Contrast Setting
215.
91
CAB DISPLAY SETUP?
CXXX
NO/YES
CXXX
DISPLAY CONTRAST
B
B
A
D
C
Revision A
Advertisement
Table of Contents
Troubleshooting
