Mitsubishi Electric FR-F800 Series Instruction Manual page 68

• NICHIFU Co., Ltd.
Cable gauge (mm
0.3 to 0.75
3.
Insert the wire into the terminal block.
NOTE
• When using stranded wires without a crimp terminal, twist enough to avoid short circuit with a nearby terminals or wires.
• Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause an inverter damage
or injury.
 Wire removal
Pull the wire while pushing the open/close button all the way down firmly with a flathead screwdriver.
NOTE
• Pulling out the wire forcefully without pushing the open/close button all the way down may damage the terminal block.
• Use a small flathead screwdriver (tip thickness: 0.4 mm, tip width: 2.5 mm).
If a flathead screwdriver with a narrow tip is used, terminal block may be damaged.
Commercially available products (as of October 2020)
• Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause an inverter damage
or injury.
Downloaded from ManualsNet.com
Blade terminal
2
)
product number
BT 0.75-11
Open/close button
Flathead screwdriver
Product
Model
name
Screwdriver SZF 0- 0,4 × 2,5
search engine
Insulation cap product Crimping tool product
number
VC 0.75 NH 69
When using single wire or stranded wire without crimp terminal,
push an open/close button all the way down with a flathead
screwdriver, and insert the wire.
Manufacturer
Phoenix Contact Co., Ltd.
number
Open/close button
Flathead screwdriver
2. INSTALLATION AND WIRING
1
2
3
4
5
6
7
8
9
10
67
2.6 Control circuit