Mitsubishi Electric FR-F800 Series Instruction Manual page 67

2.6.3 Wiring of control circuit
 Control circuit terminal layout
• Recommended cable gauge: 0.3 to 0.75 mm
*1 This terminal operates as terminal FM for the type FM inverter. For the type CA inverter, the terminal operates as terminal CA.
 Wiring method
 Power supply connection
Use crimp terminals and stripped wire for the control circuit wiring. For single wire, the stripped wire can be used without crimp
terminal.
Connect the end of wires (crimp terminal or stranded wire) to the terminal block.
1.
Strip the signal wires as follows. If too much of the wire is stripped, a short circuit may occur with neighboring wires.
If not enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder them.
2.
Crimp the terminals on the wire.
Insert the wire into a crimp terminal, making sure that 0 to 0.5 mm of the wire protrudes from the end of the sleeve.
Check the condition of the crimp terminals after crimping. Do not use the crimp terminals of which the crimping is
inappropriate, or the face is damaged.
Crimp terminals commercially available (as of October 2020)
• Phoenix Contact Co., Ltd.
Cable gauge (mm
0.3
0.5
0.75
1
1.25, 1.5
0.75 (two-wire product)
*1 A ferrule terminal with an insulation sleeve compatible with the MTW wire which has a thick wire insulation.
*2 Applicable for terminals A1, B1, C1, A2, B2, C2.
66
2. INSTALLATION AND WIRING
2.6 Control circuit
Downloaded from ManualsNet.com
∗1
2 5 4 1 F/C +24 SD
AM 5 10E 10 SE SE RUN SU
Cable sheath stripping length
2
)
With insulation sleeve
AI 0,34-10TQ
AI 0,5-10WH
AI 0,75-10GY
AI 1-10RD
AI 1, 5-10BK
AI-TWIN 2×0,75-10GY
search engine
2
So SOC SD SIC S1 S2 PC
IPF OL FU PC RL RM RH RT AU
Damaged Crumpled tip
Ferrule terminal model
Without insulation sleeve
— —
— AI 0,5-10WH-GB
A 0,75-10 AI 0,75-10GY-GB
A 1-10 AI 1-10RD/1000GB
A 1, 5-10
AI 1,5-10BK/1000GB
— —
A1 B1 C1 A2 B2 C2
STP MRS RES SD SD STF STR JOG
Unstranded
wires
Wires are not inserted
into the sleeve
Crimping tool
*1
name
For UL wire
CRIMPFOX 6
*2
CS