Mitsubishi Electric FR-F800 Series Instruction Manual page 218

 Clearing a parameter from a user group (Pr.174)
• To delete Pr.3 from a user group.
Operating procedure
1.
Power ON
Make sure the motor is stopped.
2.
Changing the operation mode
Press
3.
Selecting the parameter setting mode
Press
4.
Selecting a parameter
Turn
5.
Parameter read
Press
6.
Clearing the parameter
Turn
"
To continue deleting parameters, repeat steps 5 and 6.
NOTE
• Pr.77 Parameter write selection, Pr.160, Pr.296 Password lock level, Pr.297 Password lock/unlock and Pr.991 PU
contrast adjustment can always be read regardless of the user group setting. (For Pr.991, only when the FR-LU08 or the
FR-PU07 is connected.)
• Pr.77, Pr.160, Pr.172 to Pr.174, Pr.296, and Pr.297 cannot be registered in a user group.
• When Pr.174 is read, "9999" is always displayed. "9999" can be written, but it does not function.
• Pr.172 is disabled if set to a value other than "9999".
Parameters referred to
Pr.15 Jog frequency, Pr.16 Jog acceleration/deceleration
Pr.77 Parameter write
Pr.296 Password lock level, Pr.297 Password
Pr.550 NET mode operation command source
Pr.551 PU mode operation command source
Pr.991 PU contrast
Downloaded from ManualsNet.com
to choose the PU operation mode. [PU] indicator turns ON.
to choose the parameter setting mode. (The parameter number read previously appears)
until " " (Pr.174) appears.
. " " appears.
until " " (Pr.3) appears. Press
" and " "are displayed alternately.
selectionpage 206
lock/unlockpage 208
selectionpage 251
selectionpage 251
adjustmentpage 200
search engine
to delete the parameter.
timepage 261
5. PARAMETERS
5.4 (E) Environment setting parameters
1
2
3
4
5
6
7
8
9
10
217