Mitsubishi Electric FR-F800 Series Instruction Manual page 630

 Removal (FR-F840-04320(185K) or higher)
1.
Remove the screws attaching the fan cover, then remove the cover itself.
2.
Disconnect the fan connector, then remove the fan block itself.
3.
Remove the fan fixing screws, and remove the fan.
*1 The number of cooling fans differs according to the inverter capacity.
 Installation (FR-F840-04320(185K) or higher)
1.
After confirming the orientation of the fan, install the fan so that the "AIR FLOW" arrow faces up.
<Fan side face>
2.
Install fans referring to the above figure.
The tightening torque of the fan fixing screws is 0.73 N·m.
NOTE
• Installing the fan in the opposite direction of air flow may shorten the inverter life.
• Ensure that the cables are not caught when the fan is installed.
• Switch OFF the power before starting the fan replacement work. To prevent an electric shock accident, keep the inverter with
its covers on during fans replacement since the inverter circuits are charged with voltage even after power OFF.
Downloaded from ManualsNet.com
Fan connection
connector
AIR FLOW
search engine
Fan *1
Fan block
3)
2)
7. PRECAUTIONS FOR MAINTENANCE AND INSPECTION
Fan cover
1)
7.1 Inspection item
1
2
3
4
5
6
7
8
9
10
629