Mitsubishi Electric FR-F800 Series Instruction Manual page 581

 Writing parameter settings stored in the operation panel to the inverter
Operating procedure
1.
Connect the operation panel to the destination inverter.
2.
Selecting the parameter setting mode
Press
3.
Selecting the parameter
Turn
"
4.
Selecting parameter write
Turn
"
5.
Writing to the inverter
Press
seconds to write all the settings. During writing, "
● Perform this step while the inverter is stopped. (Parameter settings cannot be copied during operation.)
6.
End of copying
"
7.
When parameters are written to the destination inverter, reset the inverter before operation by, for example, turning
the power supply OFF.
NOTE
• "
• "
lower or FR-F840-01800(55K) or lower inverters and the FR-F820-03160(75K) or higher or FR-F840-01800(75K) or higher
inverters. When CP and 0.00 are displayed alternately, set Pr.989 Parameter copy alarm release as shown below (initial
value).
After setting Pr.989, perform setting of Pr.9, Pr.30, Pr.51, Pr.56, Pr.57, Pr.72, Pr.80, Pr.82, Pr.90 to Pr.94, Pr.453, Pr.455,
Pr.458 to Pr.462, Pr.557, Pr.859, Pr.860, and Pr.893 again.
580
5. PARAMETERS
5.15 Copying and verifying parameters on the operation panel
Downloaded from ManualsNet.com
to choose the parameter setting mode. (The parameter number read previously appears.)
to " " (Parameter copy) and press
" appears.
to change the set value to "
" appears.
to start writing the parameter settings stored in the operation panel to the inverter. (It takes about 60
" and " " are displayed alternately after copying ends.
" appears when a parameter write error occurred. Perform the operation from step 3 again.
" and " " are displayed alternately when parameter copy is performed between the FR-F820-02330(55K) or
Pr.989 setting
10 Cancels the warning of FR-F820-02330(55K) or lower and FR-F840-01160(55K) or lower.
100 Cancels the warning of FR-F820-03160(75K) or higher and FR-F840-01800(75K) or higher.
search engine
.
", then press .
" blinks.)
Operation