To Enter Commands Directly Using Telnet - Agilent Technologies 1660C Series User Manual

To enter commands directly using telnet

The syntax of the telnet command is:
telnet [symbolic name|IP address] 5025
The symbolic name is the host name of the logic analyzer as set up by your
system administrator. Typically, this name is found in the hosts file or
returned by a name server. It is equivalent to the logic analyzer's IP address.
5025 is the port identification number of the logic analyzer's command parser
socket . It must be specified because the logic analyzer is not a fully
functional telnet server. If you forget to specify the port, you will get a
connection refused message:
$ telnet 1660sys
Trying...
telnet: Unable to connect to remote host: Connection refused
To enter commands directly using telnet, first open a telnet connection using
port 5025. A brief message appears confirming the connection, and telling
you how to break the telnet connection:
$ telnet 1660sys 5025
Trying...
Connected to 1660sys.col.hp.com
Escape character is '^]'.
When you connect to the logic analyzer, there is no prompt. Type logic
analyzer commands; query results appear on the next line. When you are
done, break the telnet connection using the escape character, and type "quit".
See the detailed example on the next page.
Programming the Logic Analyzer
To enter commands directly using telnet
5-5