3300 ICP Technician's Handbook – Release 3.2
Install the System ID Module
The system ID module is shipped with the software. You must
install the system ID module in the 3300 ICP controller. The module
contains a unique identifier that the system reads on start-up.
To install the System ID Module:
1. Remove the cover.
2. Press firmly to seat the module on the board. Placement is
between MMC 1 (the Dual FIM) and MMC 8 (the DSP). The
module will cover the 'MMC 8' text printed on the board.
3. Replace the cover.
- 14 -