Mitel 3300 ICP Technician's Handbook page 109

3300 ICP Technician's Handbook – Release 3.2
Replace the Cover
To replace the 3300 ICP cover:
1. Turn the 3300 Controller until the back panel is facing forward.
2. Lift the lock for the AC power cord and place the shell at an
angle to hook onto the back of the unit.
3. Straighten and slide the cover forward as far as it will go.
4. Secure the shell by inserting and snugly securing the two
screws on the back panel.
5. Rotate the 3300 Controller until the front panel is facing
forward.
6. Turn the 3300 Controller gently upside down.
7. Secure the screws on the bottom front of the unit.
8. Turn the 3300 Controller right side up.
9. Clip on the front faceplate taking care not to damage the
protruding FIM connectors.
10. Reinstall the 3300 Controller into the rack (if applicable).
11. Reconnect all cables.
12. Power on the unit.
Dual FIM Module
CAUTION: To prevent ESD damage while handling modules on
any unit, always attach the wrist strap from the cabinet being
serviced, and immediately place any item removed from a
cabinet into an anti-static bag.
CAUTION: Do not drop screws or lock washers in the
controller.
To remove a Dual FIM Module:
1. Remove the cover.
2. Remove the two Philips screws from the faceplate in slot MMC
2
- 101 -