Install Wireless Devices - Mitel 3300 ICP Technician's Handbook

3300 ICP Technician's Handbook – Release 3.2
2. Unpack the CEPT Interface Assembly. Inspect it to ensure that
it is not damaged.
3. Set the CEPT Interface Assembly jumpers to the desired
positions.
4. Locate the slot in the DSU box that corresponds to the DSU slot
that holds the CEPT Formatter card. When you are facing the
rear panel, the DSU box slots, from right to left, correspond to
DSU slots 3/1/2 to 3/1/5, or on an SX-2000 DSU node
correspond to DSU slots 2 to 5.
5. Remove the cover plate from the slot on the metal box by
unscrewing the two screws that hold it in place.
6. Insert the CEPT Interface Assembly into the empty slot in the
DSU box, and plug it into the DIN connector in the back of the
DSU box.
7. Align the screw holes on the CEPT Interface Assembly
faceplate with the screw holes in the metal box, and fasten the
faceplate to the box.
8. Connect the cables from the external network to the BNC
connectors on the CEPT Interface Assembly.
9. Remove the anti-static strap from your wrist.

Install Wireless Devices

Installation Overview:
1. Symbol Technologies will complete a site survey.
2. Symbol Technologies will install and configure the Air Access
Points.
3. Complete Programming on 3300 ICP.
4. Configure the wireless phones using the Symbol NetVision
MiNET Phone Administrator Tool.
To migrate from a 3200 ICP the wireless network must use the
Direct Sequencing (DS) Spread Spectrum using the 802.11b
protocol. The wireless phones will be required to have new
firmware downloaded.
- 73 -