Install The System Id Module - Mitel 3300 Technician's Handbook

Technician's Handbook

Install the System ID Module

1. Remove the System ID Module from its packaging.
2. Remove the bottom cover of the Controller (see
3. Remove the protective cover from the System ID
4. Slide the System ID Module between the slots
5. Secure the System ID Module using the screw
6. If you are not installing DSP Compression Modules,
Next:
18
"Removing/Installing the Controller Cover" on
page 110).
Module's connector.
indicated below, and insert the module connector in
its mate on the Controller.
• 100-User Controller: slots 1 and 2 (see Figure 2 on
page 15).
• 250- and 700-User Controllers: slots 1 and 8 (see
Figure 3 on page 16).
provided with the module.
put the Controller's bottom cover back on (see
"Removing/Installing the Controller Cover" on
page 110).
• If you are installing a DSP Compression Module, go
to "Install the DSP Module(s)" below.
• If you are not installing DSP Compression Modules,
go to "Connect the Maintenance PC to the
Controller" on page 20.