Mitel 3300 ICP Technician's Handbook page 124

3300 ICP Technician's Handbook – Release 3.2
3. Insert the BRI card into the slot that corresponds to the BRI
interface assembly and close the locking latches.
To make the connections to the BRI card:
1. Using a BNC to BNC cable, connect the Rx port on the BRI
interface assembly to the Tx port on the CEPT interface
assembly.
2. Using a BNC to BNC cable, connect the Tx port on the BRI
interface assembly to the Rx port on the CEPT interface
assembly.
3. Using the 44-pin D-type to Amphenol cable, connect the ISDN
BRI port on the BRI interface assembly to the distribution frame,
RJ45 patch panel, or network terminating rack. (See tables for
the cable pinout; 6 circuit and 15 circuit)
Install a CEPT or DS1 Formatter II Card
Before you begin
•
Program the Card Assignment with CEPT Formatter or DS1
Formatter cards.
- 116 -