Configure The Controller - Mitel 3300 ICP Technician's Handbook

3300 ICP Technician's Handbook – Release 3.2

Configure the Controller

Note: Before you begin, you should review the LAN and WAN
guidelines and plan the network. Complete the Installation
Planner. You will need to know the IP addresses reserved by
the customer for the 3300 ICP Controller (one for the RTC and
one for the E2T) and for the IP Phones.
Time: The initial power-up and the reset in this procedure will
each take 15 to 20 minutes.
To complete the installation of the Mitel Networks 3300 ICP:
1. Connect power to the 3300 Controller. The controller will come
up, in 15 to 20 minutes, with factory-installed software.
2. To check connections between the 3300 Controller and the PC:
PING the 3300 Controller IP address
FTP to the 3300 Controller IP address
Go to the 3300 Controller URL address (http://192.168.1.2).
3. Launch browser to login to the System Administration Tool
(http://192.168.1.2 -- username is system, password is
password).
4. Optional. Install the Mitel Networks 3300 Configuration Tool on
your PC. Use the Configuration Tool to reset the default
database, import the .csv file, and make programming changes.
Refer to the 3300 Configuration Tool online help for detailed
instructions.
5. Enable the options in the License and Option Selection form
and reboot.
6. Program the system by using the System Administration Tool or
restore a database.
7. Configure the DHCP Server with IP addresses provided by the
customer. Refer to the Note and default settings table following
this procedure.
8. If you are using an external DHCP Server, disable the internal
DHCP Server.
9. Perform a Backup.
- 17 -